All NetBurner Serial to Ethernet Servers come preloaded with software to translate serial and Ethernet data, and is configurable through any web browser.  The application code can be customized to any specific application requirements with a development kit.

The serial to Ethernet server network-enables serial devices right out of the box - no programming or development is required. The hardware is pre-programmed to convert your serial data to Ethernet, enabling communication with the serial device over a network or the Internet. The onboard web server provides easy device configuration using a standard web browser

By using two NetBurner serial to Ethernet devices you can create a “serial tunnel” that enables two serial devices to communicate over an IP network, even if both of your serial devices have no network capabilities. The IP connection between the two devices will be transparent to the serial devices.

The included virtual COM port Windows utility enables you to easily access serial devices located on a  remote NetBurner device as if they were plugged into your own computer. When the attached serial port device sends communication data, it is actually transmitted over a TCP/IP or UDP network and back from the network to your serial device.

• Configuration through web browser and the NetBurner IPSetup utility
• Password protection
• Firmware updates through network or serial connections

Factory application supports up to 115,200 bps. Custom rates available with development kit.

RS-232, RS-422, RS-485 and TTL

• Two RS-232 ports, without hardware handshaking
• One RS-232 port with hardware handshaking and one RS-485/422 port
• Two TTL ports
• One TTL port and one RS-232 port
• One TTL port and one RS-485/422 port

32-bit Freescale ColdFire 5272 running at 62.5MHz with 512KB of flash and 8MB of SDRAM.

10/100 BaseT with RJ-45 connector

• Two UARTs
• SPI peripheral interface

Auto-negotiation (off/on), speed (10/100), power (off/on)

Dimensions (inches): 3.25” x 2.00”
Weight: 1.1 oz.
Mounting Holes: 4 x 0.125” dia.

DC Input Voltage: 5V @ 480mA max

0° to 70° C

The Restriction of Hazardous Substances guidelines ensure that electronics are manufactured with fewer environment harming materials.

This windows utility enables you to easily share serial port devices over the network (Internet or LAN) with NetBurner devices. When the attached serial port device sends communication data, it is actually transmitted over TCP/IP network and back from the network to your serial device.
Download : Virtual COM Port Driver

IPSetup is a Windows program used to configure NetBurner hardware through a network connection. Running IPSetup will automatically identify your NetBurner device (even if its IP address is 0.0.0.0).
Download : IPSetup

MTTTY (Multi-Threaded TTY) is an easy to use Windows serial communications program.
Download : MTTTY Serial Terminal

AutoUpdate will download a new code image to your NetBurner device. This update can be done from any point that has network access. AutoUpdate can be run as a Windows GUI application or command line.
Download : AutoUpdate